Inhaltsverzeichnis
Werbung
4 Storage tank
5 AIC activated carbon post-filter
6 UV lamp (UV and PUMP-UV models)
7 Booster pump (PUMP and PUMP-UV models)
8 AIM re-mineralising post-filter
2.3 Connections diagram (fig. 1 and fig. 2)
- The percentage of dissolved salt and other rejected elements depends on the water quality,
temperature, pressure and total amount of dissolved salts and varies according to the type of
salt or elements.
- Processing particularly turbid water or with many impurities can clog filters and/or membranes
with the consequent loss of water flow.
- Sewage water, sea water or water with chemical, physical and bacteriological conditions that
can not be subject to Reverse Osmosis (industrial water or chemical processing waste) cannot
be processed.
- Ultraviolet ray lamps are hazardous to the eyes, avoid direct exposure.
Fig. 1
BRACKET MODELS - Connections diagram
AUTO-SHUT-OFF
VALVE
FILTER
PUMP AC/DC ADAPTOR
AL
Fig. 2
FRAME MODELS - Connections diagram
AUTO-SHUT-OFF
VALVE
FILTER
PUMP AC/DC ADAPTOR
AL
2.4 Technical specifications (tab. A)
Product use in working conditions other than the TECHNICAL SPECIFICATIONS is considered
IMPROPER USE. The manufacturer cannot be held liable for any damages caused by improper
use, by failure to observe what indicated in this manual, by repairs not performed by profes-
sionally qualified personnel or due to changes and alterations to the original device functions.
2.5 Production installation
- Before installation, make sure the plumbing system has been installed as for the exhisting
rules of the state of the art.
- Install a bypass that permits unit's by-passing.
- Install a check valve from the unit to the water mains.
- For mains pressure over 8 bar (116 psi) a pressure reducer must be installed upstream from
the product. Protect the product against "water hammer" using an appropriate
anti-water hammer system (expansion vessels, shock absorbers).
- For mains pressure under 3 bar, install pump models (PUMP, PUMP-UV).
- Presence and efficiency of the grounding of the power line.
- Power line compatibility with the electrical specifications of booster pump (for PUMP models)
and UV lamp (for UV models).
INSTALLATION DIAGRAM
1 Water supply
2 Processed water tap
3 Drain bracket
4 Storage tank tap
5 UV (optional)
6 Booster pump (optional)
12
STORAGE
TANK
MEMBRANE
VESSEL
PUMP
MANUAL
FLUSH
VALVE
STORAGE
TANK
MEMBRANE
VESSEL
PUMP
MANUAL
FLUSH
PRESSURE
GAUGE
VALVE
8
3
7
1
2
CARBON
RE-MINERALIZER
POST
FILTER
HIGH
PRESSURE
SWITCH
CARBON
RE-MINERALIZER
POST
FILTER
HIGH
PRESSURE
SWITCH
1
3
4
6
5
4
POST
FILTER
UV
AL
POST
FILTER
UV
AL
2
5
6
Werbung
Inhaltsverzeichnis
