For Your Safety - Fein MOtlx 6-25 Originalbetriebsanleitung

3 41 01 101 06 0.book Seite 10 Freitag, 4. April 2008 8:33 08
en
Instruction manual for SuperCut.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Be absolutely sure to read the enclosed documentation such as the Instruction Manual and
the General Safety Instructions.
Do not touch the saw blade. Danger of sharp application tools moving back and forth.
Disconnect the compressed-air supply prior to this workstep. Otherwise there may be dan-
ger of injury caused by unintentional starting of the pneumatic tool.
Use eye-protection during operation.
Use a dust mask during operation.
Use ear protection during operation.
Use protective gloves during operation.
Confirms the conformity of the pneumatic tool with the directives of the European Com-
munity.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Weight according to EPTA-Procedure 01/2003
Character Unit of measure, international Unit of measure, national
p bar
.
3
Nm /min
V
N
n 1/min
S
L dB
wA
L dB
pA
K...
2
m/s
m, s, kg, A, mm, V, W, Hz,
N, °C, dB,
2
/min, m/s

For your safety.

Read all safety warnings and all instruc-
WARNING
tions. Failure to follow the warnings
and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this pneumatic tool before you have
thoroughly read and completely understood this
Instruction Manual including the figures, specifica-
tions, safety regulations and the signs indicating DAN-
GER, WARNING and CAUTION.
Please also observe the relevant national industrial safety
regulations (e.g. in Germany: BGV A3).
10
Explanation
bar Operating pressure
3
Nm /min Air consumption
1/min Rated oscillation rate
dB Sound power level
dB Sound pressure level
Uncertainty
2
m/s Acceleration
m, s, kg, A, mm, V, W, Basic and derived units of measure from the
2
Hz, N, °C, dB, rpm, m/s international system of units SI .
Non-observance of the safety warnings in the specified
documentation can lead to serious injury.
This Instruction Manual should be kept for later use and
enclosed with the pneumatic tool when passing it on or
selling it.
Safety instructions.
1) Work place
a) Keep your work place clean and tidy. Untidiness and
bad lighting in the working area can lead to accidents.
b) Do not operate the pneumatic hacksaw in the vicinity
of any flammable fluids, gases or dust particles where
there is risk of explosion. Pneumatic hacksaws pro-
duce sparks that could ignite the dust or vapours.