For Your Safety; Special Safety Instructions - Fein AMM 700 1.7Q Bedienungsanleitung

en
16
Symbol, character
(**)
(Ax – Zx)
Character Unit of measurement,
international
U
V
f
Hz
n
/min, min
S
°
kg
kg
kg
L
dB
pA
L dB
wA
L
dB
pCpeak
K...
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s

For your safety.

Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
hand-guided power tool for use in weather-protected
environments without water supply, using the applica-
tion tools and accessories recommended by FEIN:
– for cutting polyurethane beads for glazier work in
automobiles, lorries and busses
Explanation
Battery type
Charger type
Low oscillation rate
High oscillation rate
may contain numbers and letters
Marking for internal purposes
Unit of measure-
ment, national
V
Hz
-1
, rpm, r/min /min
°
kg
kg
kg
dB
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
Explanation
DC voltage
Frequency
Rated oscillation rate
Oscillation angle
Weight according to EPTA-Procedure 01
Weight of the power tool without battery and
application tool
Weight of the battery
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to
EN 62841 (vector sum of three directions)
Basic and derived units of measurement from
the international system of units SI.
2
– for sawing out chassis sections and removing under-
seal materials
– for sanding of chassis parts

Special safety instructions.

Hold the power tool by the insulated gripping surfaces
when performing operations where the application tool
could contact hidden wires. Contact with a "live" wire
will also make exposed metal parts of the power tool
"live" and shock the operator.
Use clamps or another practical way to secure and sup-
port the workpiece to a stable platform. Holding the
work by hand or against your body leaves it unstable
and may lead to loss of control.
Grasp the power tool in such a safe manner that your
body never comes into contact with the application tool,
especially while working with application tools such as
saw blades or other blades pointed toward the grasping
range. Touching sharp tips or cutting edges can lead to
injuries.