Dvd Player Operation; Basic Operation; General Setup Tv Display; Angle Mark - Denver TVD-2118 Bedienungsanleitung

DVD PLAYER OPERATION

Basic Operation

1. Press TV/DVD button on the remote controller or DVD button on the TV set to turn on ( or off ) DVD .
2. Press OPEN / CLOSE button to load disc into disc tray.
3. Press OPEN / CLOSE button to close the tray.
Hold the disc without touching either of its surfaces, position it with the printed title side
facing up, align it with the guides, and place it in its proper position
DVD Setup Mode
Setup Mode provides the menu for the configuration of General Setup Page, Speaker Setup Page, Dolby DigitalSetup ,
Video Setup Page and Preference Page .
Item selection in the Setup Menu is done by using the Navigation Arrows, SETUP button and the OK button.
Press the SETUP button first , enter into SETUP menu, then press the DIRECTION RIGHT button, you can enter into the next
Sub-menu.
Press the SETUP button again to exit the Setup Menu,
1. General Setup
TV Display
PS
This is selected when the DVD
player is connected to a normal
TV. Wide-screen images are shown
on the screen, but with some parts
cut automatically.
LB
This is selected when the player is
connected to a normal TV. Wide-screen images are
shown on the screen, with black belt on the top and
bottom.
Wide
This is selected when the player
is connected to a wide-screen TV

Angle Mark

This only works when there is an
angle mark on the disc. Select
ON, the screen shows the mark
when playing DVD.
.
On
Off
.

OSD Language

This is used to select the OSD language.
.
English
German
. Danish
Swedish
Spanish
Portuguese
Italian
.
12
.
TV Display
Angle Mark
OSD Language
Digital Output
Screen Saver
Set TV Display Mode
TV Display
Angle Mark
OSD Language
Digital Output
Screen Saver
Set Angle Mark
TV Display
Angle Mark
OSD Language ENG
Digital Output
Screen Saver
Set OSD Language
PS Normal / PS
Normal / LB
On
Wide
ENG
RAW
On
PS
On
O n
ENG O f f
RAW
On
PS English
On
German
Danish
Swedish
RAW
Spanish
On
Portuguese
Italian
English