Xetron DMG-10X Bedienungsanleitung Seite 9

4.System charging : Fill the system with nitrogen. When the pressure reaches the
charging warning value, Target area of the device will start to flash and a prompt will
sound at the same time.
Short press any button to turn off the prompt sound
!
5.Start leak test : click after the device reaches the pressure warning value to
start the leak test , and the timer starts counting down ( Figure 3) .
Figure 3 Pressure hold start interface
6.To end the leak test :
The test is successful: After the test is successful, the device emits a beep and jumps
to the successful result display interface (Figure 4 ).
Test failure: After the test fails, the device emits a beep and jumps to the failure
result display interface (Figure 5 ).
Forced to end the test: press and hold the button to forcibly exit the leak test
and jump to the result display interface (Figure 6 )
Figure 4 Test success interface Figure 5 Test failure interface