Xetron DMG-10X Bedienungsanleitung Seite 11

5.The interface (Fig. 7 ) displays the current pressure value of the system, the
vacuum degree of the system and the timing of entering this interface.
Figure 7 Vacuum test interface
Tips: This vacuuming function uses a non-professional vacuum sensor, which can
only be used to roughly observe the vacuum state of the system. If you want to
accurately measure the vacuum value of the system, please contact our after-sales
service to purchase a professional vacuum gauge .
3.5 Offline Recording Mode
The offline recording mode can store data in the device without Bluetooth
connection, and then export it for viewing through the APP.
Note: This function needs to be purchased before it can be used, and the purchase
method is detailed in 4.4 of this article.
1.Connect the device to the APP and enter Dashboard interface.
2.Click Settings , click Record Function .
3.Recording Interval : Click Record Interval to select the interval time.
4.Start recording : Click to Recording , the recording icon on the device lights up and
starts to flash (Figure 8 ).
The device can record up to 3000 pieces of data.
!
5.End recording : Click to Log off , and the recording icon on the device goes out.
6.Data reading : Click Read historical data and export the data.
7.Data deletion : Click Clear historical data .