Herunterladen Inhalt Inhalt Diese Seite drucken

Amewi BULLET V4.2 Bedienungsanleitung Seite 16

Inhaltsverzeichnis

Werbung

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL BULLET V4.2
IMPORTANT NOTES
WICHTIGE HINWEISE /
Schalten Sie immer zuerst die Fernsteuerung ein und verbinden Sie dann die Akkus mit dem Regler.
Anschließend ertönt eine Piepfolge, welche die fahrbereitschaft des Bootes signalisiert.
Prüfen Sie die Drehrichtung des Propelles.
Wenn Sie die Fahrt beendet haben, trennen Sie immer zuerst die Akkus vom Regler, bevor Sie die Fernsteuerung ausschalten.
Der Regler schaltet bei 3,2V pro Zelle ab. Sobald Sie merken, dass das Boot langsamer wird, fahren Sie sofort ans Ufer.
Der Regler schaltet nach kurzer Unterspannungsschutzabschaltung wieder frei. Bitte betätigen Sie den Gashebel nur im äußersten
Notfall leicht um das Boot ans Ufer zu steuern. Wenn Sie dies zu oft durchführen, werden die Akkus tiefentladen und somit nicht
mehr zu gebrauchen. Entsorgen Sie tiefentladene Akkus bei Ihrem kommunalen Entsorger.
Minimaler Wassereintritt während der Fahrt ist normal. Bitte entleeren Sie das Boot nach der Fahrt und trocknen Sie es mit einem
Lappen. Lassen Sie das Boot anschließend unbedingt offen, damit es trocknen kann und die Metallteile nicht korrodieren.
Fetten Sie die Welle, wie zuvor in der Anleitung beschrieben, spätestens nach fünf Fahrten.
Salzwasser: Das Boot ist nicht für den Betrieb in Salzwasser geeignet. Sollten Sie es doch einmal in Salzwasser nutzen, spülen Sie
es anschließen mit klarem Wasser und fetten Sie die Welle neu. Bitte beachten Sie, dass es trotzdem zu Korrosionen, bedingt durch
das Salzwasser kommen kann.
Always switch on the remote control first and then connect the batteries to the esc.
A beep will then sound to indicate that the boat is ready to go.
Check the direction of rotation of the propeller.
When you have finished driving, always disconnect the batteries from the controller before switching off the remote control.
The esc switches off at 3.2V per cell. As soon as you notice that the boat is slowing down, immediately drive to the shore.
The esc switches free again after a short undervoltage protection shutdown. Please only operate the throttle lightly in extreme
emergencies to steer the boat to shore. If you do this too often, the batteries will be deeply discharged and therefore no longer
usable. Dispose of deeply discharged batteries at your local waste disposal service.
Minimal water ingress during the trip is normal. Please empty the boat after the trip and dry it with a cloth. Be sure to leave the
boat open afterwards so that it can dry, and the metal parts do not corrode.
Grease the shaft as described earlier in the instructions, at the latest after five trips.
Saltwater: The boat is not suitable for use in saltwater. If you do use it in salt water, rinse it with clean water and re-grease the
shaft. Please note that corrosion may still occur due to the salt water.
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

26097

Inhaltsverzeichnis