Operation - Husqvarna 345BT Bedienungsanweisung

Note:
The blower nozzle can only be installed on
the intermediate pipe.
Introduction
WARNING:
safety chapter before you use the product.
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture of
gasoline and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
fuel contains less harmful chemicals compared
to regular fuel, which decreases harmful exhaust
fumes. The quantity of remains after combustion is
lower with this fuel, which keeps the components of
the engine more clean.
To mix fuel
Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION:
an octane grade less than 90 RON/87
AKI. Use of a lower octane grade can
cause engine knocking, which causes
engine damages.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION:
oil for water-cooled outboard engines,
also referred to as outboard oil. Do not
use oil for four-stroke engines.
10

Operation

Read and understand the
Incorrect type of fuel can
Do not use gasoline with
Do not use two-stroke
7. For higher air speed, attach the high speed nozzle to
the blower nozzle.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION:
the ratio of the mixture drastically when you
mix small quantities of fuel. Measure the
quantity of oil carefully and make sure that
you get the correct mixture.
(Fig. 25)
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
WARNING:
follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap. (Fig. 26)
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
Small errors can influence
Do not mix fuel for more
Obey the procedure that
1854 - 002 - 29.03.2022