Maintenance And Cleaning; General Care And Cleaning - ELEMENTI OFP101 Handbuch

Inhaltsverzeichnis

Verfügbare Sprachen

Inspecting

This outdoor fire table must be inspected regularly to insure that the product is safe to use and to

extend product life.

• Check the burner to make sure it is securely in place.

• Check the air mixer to make sure it is clear and free of

insects, spider nests and other debris(see picture).

• Check all gas connections for leaks.

• Check ignition system to insure proper sparking.

• Check components for any signs of damage, rust or excessive wear.

• If damage to any component is detected, DO NOT operate until the proper repairs have been

made.

WARNING

General Care and Cleaning

Stainless Steel

• For general cleaning use warm water, soap, ammonia, or detergent apply with a soft cloth or Sponge

• For finger prints or stubborn stains use Stainless Steel Cleaner and Polish or Stainless Shine,

apply using a soft cloth in the same direction of the polish lines.

• While using in salt air environments we recommend cleaning all stainless steel surfaces at least

every two weeks to keep the item in prime condition. Stainless steel is corrosion-resistant but it is not

impervious to rust. Exposure to salt air and sea spray will cause surface rust if you do not care for

your products properly.

• The best thing you can do to protect the stainless steel is to clean it frequently.

Fire Table Surface

Please see below for recommendations on maintaining your fireplace surface for years of extended

use:

• Clean any spills immediately to prevent permanent surface(s) staining or damage to your fireplace.

• Blot any liquid spills with a clean, dry cloth to avoid spreading of the spill to the rest of the fireplace.

• Immediate cleaning of stains I blotting of spills also prevents absorption of such stains / spills into

the surfaces, compared to if such stains / spills are left for exended periods on these surfaces.

How to apply a water based sealer:

1, This outdoor fireplace should be maintained regularly(normally 3 to 6 months) to ensure safe use

and extend product life.

2, Please ensure all treatment with dust-free. Wipe the sealers on the concrete surface slight with a

soft rags, then wipe off the residual after concrete surface dry completely.