Lighting Instructions; Turning Off - ELEMENTI OFP101 Handbuch

Inhaltsverzeichnis

Verfügbare Sprachen

Using the Ignitor

1. Read instructions before lighting.

2. Control knob must be in the "OFF"position.

3. Connect propane cylinder, slowly open valve on LP gas cylinder.

4. Push and hold igniter button to create sparks.

5. While holding the igniter button with one hand, use your other hand to push and turn the control knob

to the "LOW" position to light the burner.

6. If ignition does not occur in 5 seconds, push and turn the Control Knob to "OFF", wait 5 mimutes and

allow gas to dissipate.

7. Once the burner is lit, continue to hold the knob in for another 20 seconds and release.

8. Observe flame, make sure all burner ports are lit.

9. Adjust flame to desired flame with the control knob.

If the lighting procedure in these instructions is not followed exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

Keep the lava rock covered and make sure it is dry before igniting.

Using a Long Match or Lighter

1. Prior to lighting, use a shovel to move fire glass for access to

the burner.

2. Wearing heat resistant gloves, position the burning long match

or burning butane lighter near the side of the burner. DO NOT lean

over the fire table while lighting!

3. Turn control knob counterclockwise to "LOW".

4. Remove long match/long butane lighter.

5.After lighting, use a shovel and heat resistant gloves to carefully

move the fire glass back into their proper position.

6. Observe flame, make sure all burner ports are lit.

7. Adjust the flame to the desired height with the control knob.

WARNING

If burner fame goes out during operation,

immediately turn the control knob "OFF" and let

the gas clear a minimum of 5 minutes before

attempting to re-light the fire table.

1.Turn and push the control knob clockwise to the "OFF"position.

2.Turn the valve on the gas bottle to close.