Waring commercial TBB-Serie Gebrauchsanweisung Seite 5

9. Wash and dry the container after each use. See Cleaning
and Sanitizing Instructions.
10. Unplug to turn off all power to blender.
TBB160 – Electronic Touchpad Controls with Timer
Follow steps 1–3 from the TBB145
operating instructions.
4. This blender is equipped with
electronic touchpad controls
with HI, LO, STOP and PULSE
buttons as well as a 60-second
countdown timer. Always use HI
or PULSE for crushing ice.
NOTE: Blender can operate in two modes: Timer Mode &
Continuous Mode.
5. For timer mode, press the
the desired time on the LED display, up to 60 seconds.
Press and hold the u
p
After the time is set, press either LO or HI to start the
blender. LED will blink during blending. The timer will count
down to 0 in 1-second intervals and then the blender will
stop. Once you set a time, it will be kept and is repeatable
until reset or unplugged.
NOTE: If you want to increase or decrease the time while the
timer is counting down, press the u
as needed. Time will increase in 1-second intervals. Pressing the
PULSE or STOP button during timer mode will
stop the motor regardless of how much time is left on the timer.
6. For continuous operation, press either the LO or HI button.
When blending is complete, press STOP. For momentary
operation, press the PULSE button; motor will run on MAX
speed until the button is released.
NOTE: This blender utilizes a Slow Start
beginning HI or LO operation, the unit will start in a lower speed
for 1 second and then switch to the full selected speed. PULSE
utilizes a .5-second Slow Start
blending of ingredients in container.
7. Allow motor to come to a complete stop before removing
container from blender base. Never place the container
16wi020112_tbb_ek_series_ib_final.indd 8-9
arrow to set
up or down
arrow for fast scrolling.
or down
arrow symbols
p or down
™ feature. When
. This allows for a more even
™
8
on the motor base or remove it from the motor base while
motor is running.
8. Always hold container with one hand when starting and
while blending. Never operate without lid.
9. Wash and dry the container after each use. See Cleaning
and Sanitizing Instructions.
10. Unplug to turn off all power to blender.
TBB175 – Variable Speed Controls
Follow steps 1–3 in the TBB145
operating instructions.
4. This blender is equipped with
a Variable Speed Control Dial
that operates from speeds
1–10 and POWER, START/
STOP and PULSE buttons.
Always use Speed 10 or
PULSE for crushing ice.
5. For continuous blending, turn the variable speed control
dial clockwise to set the speed from 1–10. Press the START/
STOP button to start blending. The LED will blink during
blending. When blending is complete, press the START/
STOP button to stop blending. You may wish to start at a
low speed and increase to a higher setting.
6. For momentary operation, press the PULSE button; motor
will run on MAX speed until the button is released.
NOTE: This blender utilizes a Slow Start
beginning HI or LO operation, the unit will start in a lower speed
for 1 second and then switch to the full selected speed. PULSE
utilizes a .5-second Slow Start ™
blending of ingredients in container.
7. Allow motor to come to a complete stop before removing
container from blender base. Never place the container
on the motor base or remove it from the motor base while
motor is running.
8. Always hold container with one hand when starting and
while blending. Never operate without lid.
feature. When
™
. This allows for a more even
9
11/15/16 3:06 PM