Kostal PLENTICORE plus Kurzanleitung Seite 22

Short manual
IMPORTANT INFORMATION
The inverter may only be installed, maintained and repaired by a trained and qualified
electrician. The electrician is responsible for ensuring that the applicable standards and
regulations are observed and implemented. Work that could a ect the electrical power
system of the relevant energy supply company at the site of the solar power feed-in may
only be carried out by qualified electricians expressly authorised (licensed) by the energy
supply company. This includes changes to the factory pre-set parameters, e.g. using the
PARAKO parameterisation software.
It must be ensured that the L1-L3 phases on the inverter's AC terminal and the phases in the
grid are assigned uniformly.
If residual current protection equipment (RCD) is used, a type A RCD ≥300 mA can be used
on the AC side. Use of a type A RCD is set in the Webserver. (Default setting: compatibility
with type A RCD).
The solar modules connected to the inverter must comply with Class A of the IEC 61730
standard.
For initial commissioning, at least the "min. input voltage (U DCmin )" must be present and
there must be an output greater than the self-consumption of the inverter.
POSSIBLE DAMAGE
Risk of damage when the inverter is placed on its underside. Always place the inverter on its
rear side (cooling elements) after unpacking.
If the PV generators are incorrectly connected, the inverter may be damaged. Check the
connections before commissioning.
Installation
Perform inverter assembly, installation and commissioning based on the information provided in the
Installation chapter on page 64 onwards
Complete operating manual and warranty conditions
A detailed operating manual and further information about the inverter, such as approved energy
meters, battery storage, country settings for commissioning and approved countries in which the
inverter can be operated, can be found online a
www.kostal-solar-electric.com > Download > PLENTICORE plus > model > country >
Operating manual
Information about the service and warranty conditions is provided in a separate document
available at
www.kostal-solar-electric.com > Download > PLENTICORE plus > model > country >
Warranty
22
.
© 2020 KOSTAL Solar Electric GmbH