AEG DGK6681HM Benutzerinformation Seite 62

1. Open the glass with control panel
symbols.
2. Touch the to switch on the appliance.
3. If needed, change the speed by touching
the desired symbol.
To turn off the appliance touch
5.2 Timer
This function allows to turn off the appliance
after 5 minutes of operating. The function can
be used only if the appliance operates on first
3 motor speeds.
1. Touch the symbol.
Timer starts to flash.
2. After 5 minutes the appliance turns off.
To turn off the function touch
5.3 Hob²Hood function
It is an automatic function which connects the
hob with a hood. Both the hob and the hood
have an infrared signal communicator. Speed
of the fan is defined automatically on basis of
mode setting and temperature of the hottest
cookware on the hob. You can also operate
the fan using the hob manually. The function
can be activated from panel of the hob.
Led lamp switches on when the connection is
established between the hob and hood.
The element underneath the hood (1) is a
signal receiver of the function.
For more information how to use the
function refer to the hob user manual.
5.4 Filter notification
again.
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter.
• After 40 hours of usage, the symbol
• After 160 hours of usage, the symbol
again.
Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function touch
62
turns on for 30 seconds. The grease filter
must be cleaned.
flashes for 30 seconds. The grease filter
must be cleaned and charcoal filter must
be replaced or cleaned.
for 3 seconds.