XGIMI MoGo 2 Benutzerhandbuch Seite 14

Correct use of the device:
Do not face lens into eyes as injury to the eyes can be caused by the strong projector light.
Do not block the air inlet/outlet of the device in order to avoid damage to internal electronic
devices arising from normal heat dissipation failure of the device.
Do not wipe the lens directly with cleaning tools including paper and cloth etc. in order to
avoid damage to lens; please clean up the dust on the lens surface through clean air blowing.
Do not wash the device with chemicals, detergents or any liquid in order to avoid corrosion of
circuit board by rainwater, moisture and mineral-containing liquids.
Keep the device and its components and accessories out of reach of children.
Ensure that the device is used in a dry and ventilated environment.
Do not store the device in overheated or overcooled places, because extreme temperatures
will shorten the life of electronic devices. Permissible environ ment for storage and use of the
device in an environment of 0°C-40°C.
Do not put the device into any heating equipment (such as dryer and microwave oven etc.)
for drying.
Do not extrude the device firmly or place barriers on it or its back to avoid damage to the
device.
Do not throw, strike or sharply vibrate the device to avoid damage to the internal circuit
board.
Do not try to disassemble and assemble the device yourself. Please contact after-sales
service of XGIMI for any problem.
Do not repair any product on your own. In the case of normal operation failure of the device or
any component, you shall consult after-sales service of XGIMI promptly or return it to the
factory for repair.
Operations in the 5.15-5.35 GHz band are restricted to indoor usage only.
In the installation and operation of the device, the for distance between radiator and body
should be at least 20cm.
As with any bright source, do not stare into the direct beam, RG2 IEC 62471-5:2015
Use careful with the earphone maybe excessive sound pressure from earphones and
headphones can cause hearing loss.
Adapter plug is used as the disconnect device, so the disconnect device shall remain readily
operable.
06