IFM Electronic AS-i CONTROLLER e AC1355 Montageanleitung Seite 16

O Diagnostics
O Master Setup (information on the AS-i master system)
O Fieldbus Setup(Setting of the optional fieldbus interface)
16
(diagnostics of the connected AS-i networks)
∇ Counting the AS-i voltage dips since power on of
the controller
∇ Counting the AS-i configuration errors since
power on of the controller
∇ Verify the fault rate of the AS-i messages of the
connected AS-i system
∇ Indication of the number of connected AS-i slaves
and the cycles per second
∇ List of the AS-i slaves with faulty messages since
power on of the controller
∇ Reset of the error counter
∇ Indication of the maximum system cycle time
∇ Reading the diagnostic information of Safety-at-
Work monitors
∇ 'Teach in' of the current AS-i configuration
(project all)
∇ Changeover to the projection mode:
configuration of the AS-i system
∇ Changeover to the protected mode:
normal operation (master monitors configuration)
∇ Enable the automatic AS-i slave addressing in the
protected mode
∇ Deactivation of the AS-i reset during the change
to the protected mode
∇ Setting of the device address of the controller
the higher-level fieldbus
∇ If necessary further settings of the higher-level
fieldbus
e
e
e
in
e