ofinto Elevate Bedienungsanleitung Seite 26

TROUBLESHOOTING
ERRORCODES
Code Meaning
E00 Initialization
not com-
plete
E01 Overheating
protection
E02 Imbalance
of >10mm
E03, Collision
E04
E
E11, Overload
E12
E31, Connection
E32 issues
26
Signal Solution
Initialize the device
3 Activates automatically after
beeps >300 seconds of use of the
system. The system can be
used again after 75 sec-
onds.
2 Initialize the device
beeps
The table moves back
40mm and can then be
used again. Remove the
obstacle
In case of recurring error
messages:
• Make sure that the
power unit
on tightly and that it
cannot move.
• Make sure that the table
is on level ground.
5 Remove load from the table
beeps top.
4 Check the cable connection
beeps between the table legs and
the power unit.
is screwed
F