Adjusting The Table Height; Memory Function - ofinto Elevate Bedienungsanleitung

USE
INITIALIZATION
When the ofinto Elevate is used for the first time, the
system must be initialized. To do this, simultaneously hold
down the and
^
lowest possible height and you hear a short beep (takes
about three seconds).
HEIGHT DISPLAY
The display of the control panel shows the current height
of the table top. This display works both in centimeters
and inches. To change the unit system, press and hold the
, and keys simultaneously until «C-E» flashes on the
M
1 2
display. Then, press the
key for inches.

ADJUSTING THE TABLE HEIGHT

The control element allows you to set the table height
using the and
^
current height of the table top.

MEMORY FUNCTION

You have the option of saving up to four table positions
for later use. To do this, use the arrow keys to set the
desired height and then press and hold the
the number on the display starts to flash. Then, press the
, , or
1 2 3 4
this key., um die die Höhe unter dieser Taste zu speichern.
The height remains stored even when the table is tempo-
rarily without power.
Help and videos regarding the use
keys until the table has reached its
key for centimeters or the
1
keys. On the display, you can see the
key to save the current table position under
can be found here:
M
2
E
key until
21