Assembly&Operation - Kress KG541E Serie Bedienungsanleitung

operating cycle such as the times when the tool
is switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration exposure risk.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling & disassembling the blower
tube (See Fig. A, B)
To assemble the machine, align the click button
with click slot, then mount the blowing tubes on the
machine
To disassemble the machine, press the click button
and pluck off the blowing tubes.
Installing & removing the battery pack
(See Fig. C,D)
1.Slide the battery pack into the battery
compartment until you hear a click.
2.Press the battery release button to release
battery pack from your tool.
NOTE: After recharging, insert the battery pack
into tool's battery port. A simple push and slight
pressure will be sufficient.
Checking the battery charge condition
(See Fig. E1)
NOTE: Fig. E1 only applies for the battery pack
with battery indicator light.
The battery level can be known from the battery
indicator light by pressing the button beside
the lights. Before starting or after use, press the
button beside the power indicator light on the
battery pack to check the battery capacity.
Charging the battery pack (See Fig. E2)
Your battery pack is partly charged and needs to
be fully charged before first use.
More details can be found in charger's manual.
WARNING:The charger and battery pack are
specially designed to work together, so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or
battery pack connections because of an electrical
failure and hazard will occur.
OPERATION:
Starting & Stopping (See Fig. F )
Move the On/Off switch to the "I" or "II" position to
start, to the "O" position to stop.
WARNING! The tool runs for a few seconds
after it has been switched off.
Let the motor come to a complete standstill before
setting the tool down.
Adjusting the blowing speed with 2-speed
switch (See Fig. G)
Push the switch to "I" position, the machine runs at
a low speed, for blowing small amount of leaves.
Push the switch to "II" position, the machine runs at
a high speed, for blowing large amount of leaves or
quickly cleaning the area.
USER TIPS
- Hold the blow tube approximately 2m above the
ground when operating the tool.
Use a sweeping motion from side to side. Advance
slowly keeping the accumulated debris/leaves in
front of you.
- After blowing the debris/leaves into a pile, it is easy
to dispose of the pile.
To store your cordless blower (See Fig. H)
You can store your cordless blower by hanging it on
the wall with your own wall hanging support at the
back of the blower.
CAUTION!
- Do not blow hard objects such as nails,
bolts, or rocks.
- Do not operate the blower near bystanders or
pets.
- Use extra care when cleaning debris from
stairs or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.
11
EN