Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. INSTALLATION
2.1 INSTALLATION INSTRUCTIONS
Attention! The appliance must be placed on the solid surfaces like concrete, wood or metal
etc. Never place the appliance on flammable surfaces! (Plastics, nylon vinyl etc.)
• Follow figure F1-A and F1-B on page 2-3 for mounting instructions.
• Follow figure F3 on page 2 for safety distances.
• This appliance has IP65 protection class. It is protected against low-pressure jets of
water from any direction, meaning that it is resistant to water splashes and rain.
• Never leave or store the appliance in an outdoor enviroment where it can be exposed to
rain and snow. Always store the appliance in a dry enviroment.
• Take the product and its base out of its packaging.
• Turn the product over.
• Make sure that the holes on the bottom base and the holes on the bottom of the product
meet each other.
• Screw the bottom base and the product together using the screws that came in the box
of the product
2.2 PLACEMENT INSTRUCTIONS
DIRECT YOUR HEATER TOWARDS THE MOST APPROPRIATE ANGLE
• Do not let the light go out through the window, glasses etc. as the heater primarily heats
the locations onto which its light falls
• The appliance can be carried by lifting it on the handle, see figue 3 on page 2. Be careful
not to touch the surface of the heater if it has been working for a while. The surface of
the heater may be hot.
3. OPERATING INSTRUCTIONS
See figure 4 on page 2 to know the parts of your heater and follow the instructions below.
3.1 OPERATING VIA ON/OFF BUTTON
There is a display and On-Off button on the body of your product. You can operate your
product by plugging it in and pressing the On-Off button on the body. When you press the
On-Off button once, it will start operating with the highest level. If you press the button
more than once it will change the power level to P1, P2, P3, P4 and P5, respectively.
The heater has tip-over protection, so if you tilt it above the limited angle it will have a
warning sound and turn off. In that case you need to use the on-off button to turn the
heater back on.
7
EN
Werbung
Inhaltsverzeichnis
