Filling A Tyre Using The Car Valve; (Schrader Valve); Using The Adapter - Eufab 21084 Bedienungsanleitung

6.3 FILLING A TYRE USING THE CAR VALVE

(SCHRADER VALVE)

Open the lock on the valve connection
Place the valve connection on the valve
Lock the valve connection
You can now fi ll the tyre using the compressor
Press the ON / OFF switch (position 1 in the overview) to start the
fi lling process. During the fi lling process, the current air pressure
is shown in the display. When the preset
pressure is reached, the compressor switches off automatically.
switches off automatically. After switching off , press the
ON / OFF switch.
When lling, always pay attention to the correct
air pressure (consult the operating instructions
of your vehicle for information). The compressor
is able to supply a pressure of up to 10.3 bar.
If the pressure is too high, there is a risk of
explosion and injury.
Figure 2
Figure 3
Figure 4
Figure 5
Never allow the compressor to operate for
longer than 10 minutes without a pause,
otherwise there is a risk of overheating.
Switch the compressor o after 10 minutes
of use and allow it to cool down fully (at least
20 minutes) before starting it up again.
Never leave the compressor to operate
unattended.
After fi lling a tyre, check the tyre pressure again using a separate
air pressure tester (e.g. at a fi lling station, vehicle workshop).

6.4 USING THE ADAPTER

Open the lock of the valve connection (Figure 2). Insert the
appropriate adapter for the required purpose into the valve
connection. Lock the valve connection (Figure 4). Insert the
adapter into the fi lling connection of your leisure equipment
(ball, infl atable toys etc.). Depending on version, it is possible
that the adapter will need to be held fi rmly during the
fi lling process. Remove the adapter from the valve connection by
proceeding in reverse order, as described above.
11