Operating Instructions; Overview; Operating The Compressor; Connecting The Compressor - Eufab 21084 Bedienungsanleitung

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 ON / OFF switch
2 Switch for LED work light
3 Display with setting buttons
4 12 V input
5 230 V input 5 230 V input
6 LED work light 6 LED work light
7 Air hose with autovalve 7 Air hose with autovalve
connection connection
8 (+) button
9 (R) button for setting units
10 (-) button
14 230 V connection cable
15 Ball adapter
Figure 1: Overview
10
11 Unit for pressure
12 Pressure indicator
13 12 V car connection cable
16 Adapter Ø 8 mm
17 Adapter Ø 5 mm

6.2 OPERATING THE COMPRESSOR

Make sure that the compressor is switched
o before connecting it. The ON / OFF switch
(position1 in the overview) must not be
depressed.
In order to be able to work with the compressor, fi rst take the
air hose (Position 7 in the overview) from its holder on the back
of the unit.

6.2.1 CONNECTING THE COMPRESSOR

CAUTION
Do not connect the compressor to both the
230 V household connection and the 12 V socket
of your vehicle at the same time.
CONNECTION TO THE 12 V VEHICLE SOCKET:
Insert the appliance plug of the 12 V vehicle connection cable
(position 13 in the overview) into the 12 V input (position 4 in
the overview) of the compressor. Then insert the vehicle plug of
the connection cable into the vehicle socket. On some vehicles,
the ignition must be switched on for the on-board socket to be
active.
The compressor may discharge the battery of
your vehicle if the motor is switched o .
If you use the compressor with the vehicle motor
running, ensure good ventilation in the garage
or hall. There is a risk of poisoning!
CONNECTION TO THE 230 V DOMESTIC SOCKET:
Plug the appliance plug of the 230 V connection cable
(position 14 in the overview) into the 230 V input (position
5 in the overview) of the compressor. Then insert the plug of the
connection cable into the house socket.
After the compressor is electrically connected, the display
(position 3 in the overview) is activated.

6.2.2 PRESETTING THE AIR PRESSURE

Select the unit in which the air pressure is to be displayed by
pressing the (R) button (position 9 in the overview). By pressing
repeatedly, the following units can be set: PSI - BAR - kg/cm².
By pressing the (+) button (position 8 in the overview) the value
can be increased, by pressing the (-) button (position 10 in the
overview) the value can be decreased. overview) the value can
be lowered.
During the setting process, the display fl ashes. If no more
settings are made, the display shows the value 0.00
continuously after approx. 3 seconds.
The last settings are saved. After switching on
again, they are set again. If you now want to
work with other values, you must carry out a new
presetting.