TCS TASTA Serie Bedienungsanleitung Seite 11

Record greeting text:
f Press the door release button for 4s. A signal tone sounds and the green LED flashes.
f Speak your announcement text into the microphone.
f Briefly press the door release button to end the recording. The green LED flashes.
Ansagetext max. 10 s.
Announcement text max. 10 s
Leave a message on the answering machine:
f Press the bell button on the front-door station.
f Wait 5s. The announcement text is played.
f Speak your message on the answering machine.
The message is automatically ended after 20s. Max. 5 messages are stored.
The oldest message is automatically overwritten.
Listening and deleting a message:
f Press the light key for 4s. A signal tone sounds and all new message(s) are played in succession.
f Press the light key for 4 seconds to listen to the most recent message again.
f Press the light key again for 4 seconds to listen to the next message.
f Repeat the step to listen to further messages.
f Briefly press the function key after the end of a message. The current message is deleted.
When all messages have been deleted or listened to, the red LED and the ambient light go out.
CONFIGURABLE SETTINGS
The following functions can only be configured and activated by your electrician:
Triggering and receiving an internal call
You can call another indoor station or be called by it. The internal call can be programmed to the fun-
ction or light button.
f Briefly press the function key or light switch key. A confirmation tone is heard when the call has
reached its call destination. If the call is accepted at the called device, a speech connection is
established.
f Briefly press the talk button to accept an incoming intercom call.
Control function for additional functions
You can trigger special functions with the function key, e.g. open a garage door.
Parallel cal
In case of an incoming door, floor or internal call a second indoor station sounds parallel. The ring tone
sounds at both indoor stations.
EN
11