Programming The Remote Control; Automatic Code Search; Manual Programming - THOMSON RCT 311 D Serie Bedienungsanleitung

Teleco&Codes 26/09/05

Programming the remote control

If your remote control does not control your satellite receiver (or cable) or your television set you will
need to configure it using one of the two methods proposed:

Automatic code search

This method can be used to automatically find the
most appropriate code for your appliance.
1.
Switch on the appliance you wish to use the
remote control with.
2. Press the relevant button for this appliance
on the remote control, and while holding this
button down, press theB standby button
until the remote control light comes on.
Release the two buttons.
3.
Point the remote control at the appliance and
press PLAY .Wait until the light stops flashing.
If the appliance has not gone into standby
mode after five seconds, press the
button again to continue the search for the
next set of codes. Repeat this operation until
the appliance goes into standby mode.There
are 20 sets of codes.
4.
When the device changes to standby, press
the standby button B on the front to switch
it back on again.Then press the
set it to standby again and, if necessary, retry
until the device changes to standby.
5.
Press the STOP
until the remote control light goes off.
Code A-B
With certain devices (combined TV/DVD or other DVD player) it may happen that your DVD recorder
controls the DVD player of the other device. In this case you can adjust your remote control and the
DVD recorder on another code known as code B.
Remote control setting on code B
No. to key in
3000
Code A
3001
Code B
1.
Press and hold the
2.
With the number keys, press
3. Release the
DVD
DVD recorder setting on code B
1.
Switch on your DVD recorder.
2. Check that there is no disc in the disc tray.
3. Simultaneously press the
them when your DVD recorder displays
4. Try to control your DVD recorder with the remote control.
Note: in the event of a problem, redo the setting of both components: the remote control and your DVD recorder.
15:30 Page 4
PLAY
key to
REV
button and hold it down
Note: the remote control of your DVD recorder is set to code A
On display panel
(3000). To set it to code B (3001) follow the procedure described
DVD A
below.
DVD B
key.
DVD
, , , .
3 0 0 1
key.
,
PLAY/PAUSE AV
DVD B

Manual programming

This method involves carrying out a manual
search for the codes to be used for controlling
your other appliances.
1. Switch on the appliance you wish to use the
remote control with.
2. Press the corresponding key on the remote
control, hold it down and enter one of the
codes that correspond to the make of device
(see page 11).
If the remote control light flashes you have entered the
wrong code or it is not possible to program the remote
control.
3. Point the remote control at the appliance and
press the relevant button. Press the B key. If
the device does not switch off, try another
code.
Depending on the year of manufacture and the type
of appliance, some functions may not be available.
Certain codes may cover more functions than
others. Test the functions you can control and, if
appropriate, try other codes.
Note: when you change the remote control's
batteries, remember to reprogram it.
keys at the front of your DVD recorder and release
.
4