Safety Instructions; Fine Adjustment - schnitzer Cerealo Gebrauchsanweisung

Congratulations on the purchase of your new high-quality Cerealo mill. When developing
this product, we paid especial attention to optimizing its technical functionality and the de-
sign. Though, we could benefit from over 50 years experience with household grain mills.
Before using the Cerealo, please read the following instructions carefully and keep this
manual for use at hand. Please do not hesitate to contact us or your specialist dealer if you
require any further information.
You can also find more information on our website www.schnitzer.eu.

safety instructions

•
Please read through these instructions carefully.
•
Connect the mill to alternating current only and verify that the existing mains voltage is identical to the
mains voltage indicated on the base plate of the mill.
•
Do not use the mill in connection with running water or other liquids.
•
Do not place the mill and its connecting cables in the vicinity of hot objects.
•
Place the mill on a hard and flat surface during operation (kitchen tabletop).
•
Ideally is a place with little variations in temperature and humidity.
Please keep away from stove and sink.
•
Keep the ventilation slots unobstructed.
•
Do not clean the mill by inserting pointed objects into the milling chamber and do not use running water.
Do not use water for cleaning the stones.
•
If the connecting lead of the mill is damaged, it must be replaced by the manufacturer or the after sales
service or a similarly qualified person.
•
This mill is designed for normal household use, and is not suitable for commercial use.
•
Never leave your mill unattended in use. Keep small children away from the mill at all times.
•
Please do not pull on the wooden flour outlet.
material to be ground
& milling capacity
The Cerealo mill is suited for milling all types of grain of the size of wheat and smaller as well as corn (except
popcorn). Please use only cleaned grain. Uncleaned grain often contains small stones which may damage
the grinding stones of your mill. Use only dry grain. Damp grain may clog the millstones. Please also check
the overview on the next page.

fine adjustment

Your mill has been calibrated by hand. This has been done by grinding grain at the finest setting. Then the
„calibration nail" has been fixed at the funnel board. To adjust the fineness of the flour simply rotate the
funnel continuously between coarse and fine.
To locate the finest setting, first turn on the mill, with the empty grain funnel, and rotate the funnel clockwise in
the "fine" direction, until you can just hear the mill stones touch. Then rotate the funnel back slightly in the anti
clockwise direction, to the point just where the sound of the mill stones contact disappears. This is the closest
space between the two mill stones, and therefore the finest grinding setting. The scale below the funnel can
help you remember this setting. This point on the scale may vary slightly with changing temperature and
humidity in your kitchen.
While grinding, you can rotate the funnel in either direction, in order to produce a finer or coarser milled
product. If the mill is turned off and the funnel contains grain, do not adjust the setting to the fine setting!
This could jam remaining flour and grain between the millstones, causing the motor to stop. First rotate the
setting toward the coarse setting, turn on the mill, and then readjust the setting as desired.