Care And Maintenance; Battery Safety Instructions - Levenhuk Ermenrich Ping SM30 Bedienungsanleitung

Live wire alert
The device can detect AC cables at a 2" (51mm) depth when scanning in the stud or metal detection modes. When live AC voltage is detected,
the AC wiring alert icon (5) will appear on the screen.
Live wire detection will not work beyond a depth of 2" (51mm) from the scanned surface. Conduits encased in concrete, behind
sheer plywood, metallic wall coverings will cause very limited detection and may not be detected at all.
AC scanning mode
Press the Mode button (10) to select the live wire detection mode. The sensitivity of the device can also be adjusted in this mode, so live wire
detection goes as was described above in the "Metal detection mode" section.
Specifications
Max. detection depth
Sound alert
Light alert
Operating temperature range
Power supply
Dimensions
Weight
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.

Care and maintenance

Do not exclusively rely on the detector to locate items behind scanned surfaces. Do not assume that there is no live cabling inside a wall.
Always use caution when nailing, cutting, or drilling in walls, floors, and ceilings that may contain live cabling. Calibrate the device regularly.
Do not try to disassemble the device on your own for any reason. For repairs and cleaning of any kind, please contact your local specialized
service center. Protect the device from sudden impact and excessive mechanical force. Store the device in a dry cool place. Only use
accessories and spare parts for this device that comply with the technical specifications. Never attempt to operate a damaged device or a
device with damaged electrical parts! If a part of the device or battery is swallowed, seek medical attention immediately. Keep away from
children.

Battery safety instructions

Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as
prescribed by your country's laws.
Levenhuk International Lifetime Warranty
All Levenhuk telescopes, microscopes, binoculars, and other optical products, except for their accessories, carry a lifetime warranty
against defects in materials and workmanship. A lifetime warranty is a guarantee on the lifetime of the product on the market. All Levenhuk
accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles
you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions
are met.
For further details, please visit: www.levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
live wire: 51mm (2")
metal: 60mm (2½")
wood/metal studs: 13mm (½"), 25mm (1"), 38mm (1½")
+
+
0...+40°C (operating), −10...+50°C (storage) /
+32...+104°F (operating), +14...+122°F (storage)
1pc 9V battery
155x70x30mm (6.1x2.7x1.2in)
158g (0.3lb)
5