Red Sea C-130 Installationsanleitung Seite 21

7. Make sure that the hood fits securely around the rim of the tank; it
may be necessary to adjust the position of the hood support to do
this.
8. Place the timer cover onto the hood.
9. Hold the skimmer cover in the "open" position over the skimmer
chamber, lining up its hinge holes with those of the hood.
10. Insert the hood pins (that were removed for unpacking), attaching
both the skimmer panel, timer panel and hood to the hinge brackets.
Both panels should open and close easily with the pins securing the
hinge.
11. Thread the hood power cable through the cable channel and plug the
power cable into the designated socket on the power center.
12. Plug the fan cable into the receptacle on the water cooling fan.
13. Raise the skimmer panel to the upright position and reassemble the
skimmer collection cup on the skimmer body.
Securing the hood and switching between the 3
opening positions
a b
1. Make sure you have the upper hood support pin at the ready and fold
back the front section of the hood so that it lays on the main body
(figure a).
2. With one hand, raise the hood approximately to a 30° angle and hold
it open in this position (figure b).
3. With your free hand, snap the upper and middle arms of the hood
4. Lower the hood until the lower support arm is resting on the glass.
5. To obtain full access to the aquarium raise the hood to the full extent
6. To close the hood first lower the hood to the intermediate position,
c
When removing the hood from the aquarium make sure that the
power cable or fan cable do not fall in the water.
supports together and position the hole at the top of the upper arm
in the recess provided in the hood. Insert the upper support pin to
connect the support to the hood. If you experience difficulty, check
the alignment of the pins with the hole and try again.
This intermediate position provides good access to most of the
aquarium with the light mainly directed across the water surface.
of the hood support arms. Push the lower join of the arms towards
the hood and gently lower the hood until it is supported in an almost
upright position (figure c). It is advisable to make sure that the lights
are switched off before raising the hood to the full open position.
then unlock the middle and upper support arms and gently lower the
hood to rest on the color trim.
NOTE: To disassemble the hood from the aquarium, raise the hood to
the intermediate position remove the upper hood support pin by
inserting the end of a small flathead screwdriver into the small
recess in the head of the pin. Thereafter, remove the hood pins
from the hood hinges at the back.
DO NOT attempt to remove the hood support by prizing open the
support joint.
ENG
17