Red Sea C-130 Installationsanleitung Seite 13

5.3 Cable Channels
Attach the 2 cable channels to the rear wall
of the aquarium.
5.4 Placing Aquarium
Lifting the glass aquarium onto the cabinet
will require at least 2 people. The top of the
cabinet is approximately 85cm (33") from
the floor. Ensure that anyone lifting the aquarium is physically suitable
for such an operation and has been instructed in the correct methods of
lifting heavy objects.
Aquarium must be lifted from the bottom.
Take care not to damage the plastic rim on the front and sides at the
top and bottom of the glass. Slight damage to the rim will not affect the
assembling of the external color trim.
Before lifting aquarium, place the assembled cabinet in the final
operating position (see location above) and set the glass aquarium in
position on top.
The back of the glass should be flush with the rear edge of the cabinet
top board. The front and sides of the glass should protrude slightly
beyond the edges of the cabinet board such that the protrusion is
approximately even on both sides. Incorrect positioning of the aquarium
on the cabinet will interfere with the assembly of the color trim.
Once the aquarium is correctly aligned with the cabinet, check that the
cabinet has not moved. If necessary readjust the position of the cabinet.
5.5 Color Trim
The color trim pack contains a set of plastic parts for the upper and lower
rim of the aquarium that are painted to the designated color.
The color trim for the upper and lower trim are fitted by sliding them on
to their corresponding black rim that is located along top and bottom
edges of the aquarium.
Cable Channels
1
First assemble the top and bottom sides by sliding in from the front and
initially push them until they protrude about 75mm (3") out the back
side of the aquarium. Note that the corner connector on the side sections
should be facing the front.
Slide the top and bottom front sections and assemble the corners on the
corner connectors. Adjust the trim so that the small gap between the trim
and the corner is even on both sides.
Slide the side sections forward into the correct position.
Insert the rear trim covers into the back of the side sections.
2 3
ENG
4
9