Red Sea C-130 Installationsanleitung Seite 17

Assemble the skimmer as shown in the diagram.
1. Set the skim adjuster to its lowest position.
2. Connect the air pipe from the venturi inlet of the skimmer pump to
the outlet of the silencer.
3. Connect the small air pipe on the inlet of the silencer.
4. An optional air valve is provided for use with the skimmer. Initially do
not attach the air valve; it is only to be used if required as described
in the operation instructions (chapter 11; page 19).
5. Slide the skimmer into the skimmer compartment. Note the position
of the skimmer guides located on the inner wall of the rear sump.
6. Feed the power
cable out of the
opening in the
right hinge bracket
above the rear
wall, thread the
cable through the
cable channel and
plug the power
cable into the
designated socket
on the power
center.
7. Remove the
collection cup
from the skimmer
body until after
assembling the
hood on the
aquarium.
d
c
MSK 600 skimmer
6.2 Surface Skimmer:
The comb sections of the surface
skimmer are easily removed for
regular cleaning. Put your hand over
the surface skimmer. Hold the comb
(not the frame) between thumb and
fingers and pull upwards.
6.3 Media Rack:
The media rack is supplied pre-
assembled and placed in its normal
operating position within the media
compartment of the rear sump.
Familiarize yourself with the media
rack by removing and reinserting it to
the media compartment.
6.4 Carbon:
Wash the carbon filter material
under running water several times
to remove residual dust. It is
recommended to soak it in water for
24-72 hr. before usage otherwise
during the first 3 days after set-up the
carbon may float and release micro air
bubbles from inside its pores.
Place the washed carbon onto the designated shelves on the media rack.
Ensure that the bag does not protrude outside the frame of the rack.
ENG
Surface Skimmer / comb
Media Rack
13