Maintenance; Technical Data - Kress KG285 Bedienungsanleitung

J2
Lubricating the cutting blade (See Fig. K)
NOTE : It is important to use only the
recommended standard lubricating oil (WD-40) to
avoid damage to the blade.
K
EN
HOW TO USE YOUR
HEDGE TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the Operator Presence Switch and Throttle
Trigger before attempting to clear jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
10
Top cutting
Use a wide sweeping motion A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.

MAINTENANCE

Remove the battery from Hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C.

TECHNICAL DATA

Type KG285 KG285.X (250-299- designation of
machinery, representative of cordless hedge
trimmer)
Voltage
40V
No-load speed
Blade length
Cutting length
Tooth spacing
Max cutting
diameter
Machine Weight
(Bare Tool)
** X=1-999,A-Z,M1-M9 there are only used for differ-
ent customers, there are no safe relevant changes
between these models.
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal volt-
age is 18 volts.
KG285 KG285.X **
MAX(2x20V MAX.) ***
3400 /min
61 cm
58 cm
33 mm
27 mm
2.7 kg