Kress KG285 Bedienungsanleitung Seite 8

D2
NOTE :
• This machine will only run when 2 batteries
are installed. It is recommended to use the
same two batteries and charge the two
batteries at the same time.
• When you use two batteries with different
power, the machine will only run to the lower
common denominator.
OPERATION
Power indicator light (See Fig. E)
See details in BATTERY STATUS part
EN
E
11
IMPORTANT:
When only one light is illuminated, your battery is
overly discharged, even though the trimmer may
still be capable of hedge trimming. Continuing
to operate your trimmer with the battery in this
discharged condition may reduce the life and
performance of your battery.
When no light is illuminated, at least one battery
is not fully installed or battery may be defective,
please double check the batteries are fully
seated into position.
• Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
8
displays the battery condition as follows.
• For the machine with 2 battery packs with different
power, the power indicator light displays the
battery condition with the lower one of the two
batteries.
Battery indicator light
status
Five green lights
( ) are
illuminated.
Two, three or four green
lights are illuminated.
Only one green light
( ) is
illuminated.
No light is illuminated.
Only one light is
flashing twice per cycle.
Only one light is
flashing three times per
cycle.
Only one light is
flashing four times per
cycle.
Remove the blade sheath (See Fig. F)
F
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
almost depleted and needs
to be charged.
At least one battery is not
fully installed or battery may
be defective.
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Remove tool from cutting
area and try again.