Operation Safety Zone; Angle Adjustment Of Accessory; Troubleshooting; Technical Specifications - Texas A/S COMBI 800 Bedienungsanleitung

Operation safety zone

Do not leave the operation safety zone marked in fig 5,
while working with the machine. If it is necessary
toleave the operation zone, for example to readjust the
rotary brush or to attach an accessory, first stop the
engine.

Angle adjustment of accessory

The accessory can be pivoted 20 degrees to either
side. This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.

Troubleshooting

Problem Solution
The engine won't start:
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
The engine runs unevenly:
1. Check that the choke has been released.
2. Check fuel for impurities.
If the brush will not run:
1. Check that the clutch is adjusted
correctly.
2. Check that the belt is tight.
If the machine will not run:
1. Check that the clutch is adjusted
correctly.
2. Check the belt.
If the machine does not sweep effectively:
1. Check the distance between the brush
and working surface.

Technical specifications

Combi 800
Model
TG
Length
80
(mm)
Width
70
(mm)
Height
100
(mm)
Weight,
56
dry (kg)
Wheel size 4.8-8
Engine
TG720S
model
Engine Texas
brand Powerline
Combi 800 Combi
TGE 800 B
80 80
70 70
100 100
56 56
4.8-8 4.8-8
TG720ES 950
Texas
B&S
Powerline
11