Before Calling For Service; Possible Cause; Specifications - Uspa UB-6635R Bedienungsanleitung

10 Before calling for service

Problem
Completely fail to work
Water does not spray
Water is leaking or dripping
Seat, water or air is not
enough warm

11 Specifications

Item
Standard power supply
Way of connection
Water
supply
Water pressure
Spray for cleansing
Spray for bidet
Cleansing Water capacity
Spray temperature
Heat capacity
Safety feature
Air temperature
Dry Heater capacity
Safety feature
Seat temperature
Heated
Heater capacity
seat
Safety feature
Deodorization method
Length of power cord
Circuit breaker
Dimensions
Weight
Recommended water supply pressure are 0.1 MPa~0.69 MPa.
The minimum available water supply pressure is 0.08 MPa~0.1 MPa, however under 0.1 MPa water spray pressure might not be strong enough.
16

Possible cause

Is there a power cord outage?
Is the power cord unplugged?
Are you sitting on the seat correctly?
Is the water shutoff valve closed?
Is the strainer clogged?
Are the nozzles clogged?
Check if all hoses are tightened properly
Is the temperature set to OFF?
Is the appliance used in economy mode
during a cold weather?
UB-6635R
Thermal switch, Temperature fuse, Floating switch
(W)392mm x (L)520mm x (H)145mm (W)392mm x (L)490mm x (H)145mm
4.4 kg
Solution
Check for a power cord failure or a tripped breaker
Plug the power cord in properly
Sit on the seat completely
Open the shutoff valve
Clean the strainer
Clean the nozzles
If water is still leaking or dripping, contact your dealer
Reset the temperature
Release the economy function
UB-6635RS
220-240 V~ / 50/60 Hz, 1160-1380 W
Direct connection to tap water
0.08 MPa ~ 0.74 MPa
Room temp ~40 °C (104 °F)
220-240 V~ / 1100-1309 W
Off ~ 60 °C
220-240 V~ / 280-333 W
Temperature fuse, Bimetal
Room temp ~40 °C (104 °F)
220-240 V~ / 55-65 W
Temperature fuse
Active carbon filter
1.5 m
Within 15mA 0.03 second
4.3 kg
UB-6635RU
(W)392mm x (L)504mm x (H)145mm
4.4 kg