Uspa UB-6635R Bedienungsanleitung Seite 13

Identification
- This function is useful for public toilets, when more than one unit of this product is installed.
- To prevent interference among units, main unit and remote control should be set with the same ID.
- If there is only one USPA device with remote control in the bathroom, there is no need to set an ID.
- Initial ID of remote control and main unit is "0". There are 16 ID codes available (00~15).
How to set ID
[REMOTE CONTROL]
- Press "High" for 3 seconds and the ID will show up in the display.
- Press "High" or "Low"
- Press "Stop" to save the ID.
Set the unit
- After assigning the ID to the remote control, unplug the unit and the plug it back in.
- Press the "Power|Bidet" button on the left side (see picture aside) to turn off the unit.
- Press the "Power|Bidet" button again without releasing (the unit should turn back on at this point).
- While holding the "Power|Bidet" button down, push "Stop" on the remote control for 2 seconds.
Note
- If the IDs of the remote control and the main unit are different, the remote can't work properly. Make sure that remote control and
main unit are set with the same ID.
- The ID will be memorized even when the device is unplugged or when the batteries of the remote control are replaced.
until your ID appears in the display.
11
11
11