Blow Function - Ferm VCM1004 Bersetzung Der Originalbetriebsanleitung

5. Place the top section (8) on the container (7) as
shown in Fig. E-1.
6. Reattach the top section (8) again and lock the
locking clamps (5). Fig E-2.
7. Insert one end of the hose (9) into the
vacuuming port (3).
8. Place the battery (14).
9. Press the power switch (1) into the
"ON/1"position to start your ash cleaner.
10. The machine now is ready to use for vacuum
cleaning.
11. Press the power switch (1) into the "
OFF/0"position to switch off your ash cleaner.

Blow function

Fig. E-1, E-2, G
Operation without the use of a filter is
recommended.
Remove all dirt and debris from the
container(7) before you use the blow
function.
Always wear safety goggles before using
the blowing function.
Risk of flying objects. Keep bystanders
away from the work area.
Your ash cleaner is equipped with a blowing
function. This function can be used to blow ash
remains and dust out of corners and crevices
which are difficult to access with vacuuming.
1. Switch off (1) the machine and remove the
battery (14).
2. Unlock the locking clamp (5) and remove the
top section (8).
3. Before blowing, remove the filter (12) and
remove all dirt and debris from the container (7).
4. Reattach the top section (8) again and lock the
locking clamps (5). Fig. E-1, E-2.
5. Insert one end of the hose (9) into the blowing
port (4) on top of machine. Fig. G.
6. Place the battery (14).
7. Press the power switch (1) into the "
ON/1"position to start your ash cleaner.
8. The machine is now ready for blowing ashes
and dust.
9. Press the power switch (1) into the "
OFF/0"position to switch off your machine.
Finish operation
Fig. A
1. Turn off (1) the machine and remove the
battery (14).
2. Remove the top section (8) and empty the
container (7).
3. Clean the machine with a soft cloth.
4. Disconnect hose, tube and container.
5. Clean hose connectors, hose and tube after
use, and keep them unblocked.
6. Stow away the hose and accessory at the
machine. Store the appliance in a dry room.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
Filters
Fig. D
For optimal performance it is
recommended to regularly change the
filter (12) depending on level of use.
1. Carefully remove HEPA filter (12).
2. Clean the dust on the HEPA filter (12) with
a brush, and if necessary, wash it.
3. Do not use cleaning products, solvents
or sharp objects for any cleaning of the
appliance, this includeds the washable HEPA
filter
4. Allow filter to air dry before installing and using
again.
5. Reinstall the filter.
9