Technical Data - RECHNER SENSORS K 130-Serie Bedienungsanleitung

Technical Data

Typ
U
[V]
K 130/... 10
Technical Data
Sensor type
Switching points
Rated voltage
Power consumption DC
Operating mode
Line monitoring
Max. switching frequency
Permissible operating temperature
For Ex-i version
Storage temperature
Relative humidity
LED-display
Degree of protection IEC 60529
Galvanic isolation:
The output current circuits are galvanically separated from each other and from all other current circuits up
to a crest value of the nominal voltage of 60 V. The sensor current circuits are galvanic connected to the
supply current circuits.
Mechanical contacts have to be fitted with resistors as shown (figure 1a)
270 Ω
(1)
3K
(3)
Figure 1
12
I
O O
[mA]
82
C [nF]
P
O
O
[mW]
IIC
205 740
Change-over mechanical contacts or 2 wire initiator
NAMUR DIN 60947-5-6
0 ≤ 9 mA, 1 ≥ 12 mA
24 V AC / DC: 24 V ± 20%
Changeable (see table on page 13)
Integrated with LED-display
-25 °C +60 °C
-25 °C +60 °C
-25 °C...+85 °C
Green / Yellow
L [mH]
O
IIB IIC
3500 2
3.6 W
10 kHz
≤ 75 %
IP 20
IIB
5