Troubleshooting - HOLZMANN-MASCHINEN MKS 355ECO Betriebsanleitung

TROUBLESHOOTING

Manipulating the machine with the power supply up may result in serious injury or
death. Always disconnect the machine from the power source before carrying out any
troubleshooting work and secure against unintentional reconnection!
Many potential sources of error can be excluded in advance if the machine is connected correctly
to the power source.
If you are unable to carry out necessary repairs properly or do not have the required training,
always consult a specialist workshop to remedy the problem.
Fault
Machine does not start
Saw blade does not reach
speed
Machine is unusually loud
or vibrates strongly
Overheating
HOLZMANN MASCHINEN GmbH
W A R N U N G
Possible Cause
• Machine is not connected
• Fuse or protection broken
• Cable loose
Cable damaged
•
• Extension cable too long
• Motor not suitable for
existing voltage
Weak grid
•
• Workpiece badly clamped
• Stands on uneven ground
• Motor mounting is loose
Saw blade has unbalance
Internal damage or wear
•
(e.g. carbon brushes)
• Machine overstressed
• Saw blade worn or blunt
www.holzmann-maschinen.at
TROUBLESHOOTING
Remedy
• Check electrical plug
connections
• Replace fuse, activate
protection
• Check cable
• Replace cable
• Exchange to suitable
extension cable
• see switch box cover for
correct wiring
• Contact specialist electrician
• Clamping the workpiece
correctly
• Re-aligning the machine
• Tighten the fixing screws.
• Replace saw blade
• Check carbon brushes and
replace if necessary
• Press saw blade less hard
against the workpiece
• Sharpen or replace saw blade
24
MKS 355 E
CO