Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 button: This button moves the cursor to the left or
selects an item on the setup menus.
5 button: This button moves the cursor to the right
or selects an item on the setup menus.
– button: This button selects a character or a para-
meter on the setup menus.
+ button: This button selects a character or a para-
meter on the setup menus.
5. Menu Button (MENU)
Pressing this button for approx. 2 seconds displays
the setup menus. Pressing it again for approx. 1
second cancels the display of the setup menus.
6. Video input Connector (VIDEO IN 1, 2, 3, 4)
These connectors receive a composite video signal.
They are automatically terminated.
Notes:
• The input signals must meet the CCIR B/W
video signal standard, if the video inputs of this
unit are to be synchronized.
• If the input signals have a high jitter content, as
in the case of a VTR playback picture, it may
not be possible to synchronize this unit.
All manuals and user guides at all-guides.com
ALARM RECOVER IN
ALARM RESET OUT
Not Used
ALARM OUT
Not Used
Not Used
13
12
11
25
24
GND
Pin-14 to 25 are connected to Ground
-4-
7. Video Output Connectors
(VIDEO OUT 1, 2, 3, 4)
The video input signals connected to the VIDEO IN
connector are looped through to these connectors.
Connectors a coaxial cable to these connectors
cancels the termination.
8. VTR Output Connector (VTR OUT)
The video signal for the quad picture mode is
always provided at this connector. By connecting it
to the VIDEO IN connector of the time lapse VTR,
you can record the quad picture.
9. Video Output Connector (VIDEO OUT)
The video signal selected by the QUAD/SEQ button
(quad picture) or the VIDEO SELECT button (single
picture) is output from this connector.
10. Alarm/Remote Control Connector
(ALARM/REMOTE)
This connector accepts the alarm signal from asso-
ciated alarm sensor units and the remote control
signal from the external equipment.
QUAD/SEQ
Menu
Selector
REMOTE/ALARM 4
10
9
8
7
6
5
4
23
22
21
20
19
18
17
Caution: The input voltage should be DC 24V or
less for ALARM IN.
11. Power Cord
REMOTE/ALARM 3
REMOTE/ALARM 2
REMOTE/ALARM 1
3
2
1
16
15
14
Werbung
Inhaltsverzeichnis
