Kress KG154E Bedienungsanleitung Seite 13

More details can be found in charger's manual.
Battery power indicator on the
machine(See Fig. D5)
See details in BATTERY STATUS section
OPERATION:
To start (See Fig. E)
WARNING! The cutting head continues to
rotate after the trimmer has been switched off;
wait until it has completely stopped then lay down
the tool. Press the lock-off button first, then press
the switch trigger to start the machine.
ECO Speed (See Fig. F)
For longer run time, press the ECO button and
switch trigger, then your machine will operate at a
low speed
Trimming (See Fig.G)
Bump feed(See Fig. H)
Assembling and removing the trimmer head
(See Fig. I)
Insert the hex key into the hole and rotate the trimmer
head until it stops in a locked position. Then, rotate
counterclockwise to remove it, and clockwise to
assemble it
Winding the trimmer line (See Fig. J1,J2)
NOTE: The spool must be wound while inside the
trimmer head. The spool cannot be wound with line,
then installed into the trimmer head
BATTERY STATUS (See Fig. D5)
Before starting or after use, press the button beside
the power indicator light on the machine to check the
battery capacity. During operation, the battery capacity
will be indicated automatically by the battery power
indicator.
The indicator constantly senses and displays the
battery condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Five green lights (
) are
illuminated.
Two, three or four green
lights are illuminated.
Battery condition
The two batteries are
in a highly charged
condition
.
The two batteries have
a remaining charge.
The more lights are
illuminated, the more
battery capacity.
Only one green
light ( )
is illuminated.
No light is illuminated.
Only one light is flashing
twice per cycle
Only one light is flashing
three times per cycle
.
Only one light is flashing
four times per cycle
.
OPERATION
INSTRUCTIONS
Warning! The charger and battery pack are
specially designed to work together so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or
battery pack connections because of an electrical
failure and hazard will occur.
1. Bump-line feed system (See Fig. H)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
running, new line will feed out.
2. Winding the trimmer line (See Fig.J1,J2)
Insert the replacement line through the eyelet and
feed it through the other side. Ensure both ends of
the line are even on each end of the trimmer head
(recommended 7') and cut the line. Turn the dial
clockwise to wind the line around the spool until about
7.5" remains on either side.
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from your
trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for storing
the trimmer on the wall. (See Fig. K)
Store in a dry place where the trimmer and battery can
be protected from damage.
At least one battery is
almost depleted and
needs to be charged.
At least one battery
is not fully installed
or battery may be
defective.
At least one battery is
over discharged (please
refer to the battery
charge condition),
please recharge the two
batteries at once before
use again or storage.
At least one battery is
hot, wait for them cool
down before start again.
The machine is over
load. Raise the cutting
height or push slowly
13
EN