Herunterladen Inhalt Inhalt Diese Seite drucken

LD Systems MAUI G3 Serie Bedienungsanleitung Seite 5

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
ATTENTION:
1. Do not operate the unit if it has been exposed to large temperature fluctuations
(for example, after transport). Moisture and condensation could damage the unit. Do not
switch on the unit until it has reached ambient temperature.
2. Make sure that the voltage and frequency of the mains supply match the values indicated
on the unit. If the unit has a voltage selector switch, do not connect the unit until it is set
correctly. Only use suitable mains cables.
3. To disconnect the unit from the mains at all poles, it is not sufficient to press the on/off
switch on the unit.
4. Make sure that the fuse used corresponds to the type printed on the unit.
5. Make sure that appropriate measures have been taken against overvoltage
(e.g. lightning strike).
6. Observe the specified maximum output current on units with Power Out connection. Make
sure that the total current consumption of all connected devices does not exceed the
indicated value!
7. Replace pluggable mains cables only with original cables.
DANGER:
1. Danger of suffocation! Plastic bags and small parts must be kept out of reach of persons
(including children) with reduced physical, sensory or mental capabilities.
2. Danger from falling down! Make sure that the unit is securely installed and cannot fall
down. Use only suitable stands or mountings (especially for permanent installations).
Ensure that accessories are properly installed and secured. Make sure that applicable
safety regulations are observed.
WARNING:
1. Use the appliance only in the manner intended.
2. Operate the appliance only with the accessories recommended and intended by the
manufacturer.
3. During installation, observe the safety regulations applicable in your country.
4. After connecting the unit, check all cable routes to avoid damage or accidents,
e.g. due to tripping hazards.
5. Be sure to observe the specified minimum distance to normally flammable materials!
If this is not explicitly stated, the minimum distance is 0.3 m.
CAUTION:
1. In the case of moving components such as mounting brackets or other moving
components, there is a possibility of jamming.
2. In the case of units with motor-driven components, there is a risk of injury from the
movement of the unit. Sudden movements of the equipment can lead to startle reactions.
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis