Konig & Meyer Easy Lock Nutzungsinformation Seite 6

Assembly
!When attaching the speaker, there is a risk of crushing between the components!
!Due to the position of the speaker there is a risk of falling parts!
1.) Unpack and check item for damage and completeness
The adapter sleeve is pre-assembled.
2.) Place the adapter sleeve and speaker on the stand.
 The stand is securely set up.
 The stand rod is in the lower end position.
 The clamping sleeve is in the open position.
Set the adapter sleeve 1 completely on the stand and
screw the clamping screw 2 into place so it is hand-
tight.
Set the speaker on the expanding mandrel 3. The ex-
panding mandrel must be fully inserted into the flange
bushing.
3.) Place and release tension on the speaker
To place tension on the speaker: Turn the
clamping sleeve to the left 1, pull downward 2
and move to the left again 3 into the close
position. In this position, the clamping sleeve
will click into place and the speaker will be
placed on the expanding mandrel with no
play. To remove the speaker, follow the same
steps in reverse.