Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GME 11 (dis. 1) - GME 88 (dis. 1A)
The appliance is designed to exhaust fumes and odours very silently and in the best way. It must be
installed in the house and connected to the cooker-hood, which is in the kitchen (fig. 2).
Types of installation: to make the installation easy, the appliance can be fixed on the wall, on the cei-
ling or on the floor in a horizontal position (fig. 3 ) or vertically (fig. 4) to the fixing level.
Note: in the vertical fixing, the brackets supplied can be used only on the longest side (fig. 9).
Installation of the appliance: after deciding the position and the type of installation, insert the anti-
vibration rubber caps in the holes of the brackets supplied (fig. 5C).
The rubber caps must be put on the sides which are in contact with the wall.
Put the brackets (fig. 5A) on the remote fitted extraction motor by matching its holes with those of the
brackets. Fix with the screws supplied (fig. 5B).
Put the group on the point previously chosen for the installation and mark the points on the wall where
the holes must be drilled.
Insert the dowels supplied in the holes (fig. 9A). Put the remote fitted extraction motor on the wall by
matching the holes of the brackets with the plastic dowels. Screw with the screws supplied (fig. 9B).
Connecting the pipes: the device is set up with an inlet and an outlet for connecting the pipes (check
the direction of the air using the external label before mounting the evacuation pipes fig. 7).
Place the protective detail inside the air evacuation pipe (picture 6), connect the pipes and secure them
with suitable metal clamps (fig. 7).
Att: pipes and clamps are the responsibility of the installer, fix the metal protection using the special
screws supplied to GME.
The pipe (dis. 7A) must be connected to the hood located in the kitchen, the pipe (dis. 7B) must be
directed towards the outside of the building.
Connect the the external motor's cable to the terminal board found in side the plastic box of the
wiring . Make sure to respect the colors of cables when performing the electrical connection
(fig. 11).
11
Werbung
