Uniks R18 Bedienungsanleitung Seite 11

5-4.Verify Operation
Before using tester, (1) Make sure the green LED is glowing,
(2) Check tester on a known live AC voltage that is within
the defined detection range of the tester.
5-5.High Voltage Mode (100 to 1000V AC)
• Place the tip of the tester near an AC voltage.
• If the tester detects voltage within the defined detection
range, the green LED will turn off, the red LED will turn on,
the beeper will beep rapidly.
5-6.Phase Sequence Test Mode
• Place the tip of the tester close to the L1 phase wire, the
tester will beep once, the green and yellow LED flash rapidly
alternately to indicate that the measurement of the first
phase sequence is complete.
• Move the tip of the tester close to the L2 phase wire,
when the measurement is complete there will be two
results:
1.The tester beep and green LED on about 5 seconds to
indicate that is Correct phase conformity (L2 is ahead of L1
120 degrees).
2.The tester beep and yellow LED on about 5 seconds to
indicate that is Incorrect phase conformity (L2 is lag of L1
120 degrees).
• Test L1 and L3, L2 and L3 in the same way
Note: To improve test accuracy, do not place the tester tip
in the middle of the two phase lines
Note: If the phase sequence test is not completed within 1
minute, the red LED is constantly on, the green and yellow
LED flash alternately, and the tester will beep 5 times to
indicate that phase sequence test is wrong, and the test
will reset the phase sequence test mode, it need to
measurement L1 again
5-7.Low Battery Indication
• Replace the batteries if the mode indication LED does not
turn on.
batteries are too low for
• When the tester is on and the
reliable operation, the tester will
beep three times and
the mode indication LED turn off indicating the tester is not
operational.
• Replace the batteries to restore operation
11