seconds, but lights up continuously instead, the device
cannot be reset!
In this case, coding is activated using a system se-
curity key that differs from the one supplied with the
product. To reset the device, you will have to reset
using the central control unit configuration software!
The procedure to follow is described in the manual for
the central control unit software.
10 Device LED feedback messages
During normal operation the 16 channel LED's display
the status that has been transmitted by the central
control unit. The displays shown in the following tables
can also occur:
One channel LED (1 to 16)
After pressing the up or down button
(transmit channel selection)
Rapid flashing in orange
40
Select transmit channel,
the flashing channel is
used for transmission