Operation - HomeMatic HM-OU-LED16 Installations- Und Bedienungsanleitung

- Switch the central control unit to teach-in mode.
- One of the two following teach-in variants can then
be used:
1. Also switch the status display to teach-in mode by
pressing the "learn" button for approx. 5 seconds
until the LED at the top left starts to flash slowly in
green.
Release the button, and the LED now signals the
teach-in procedure by flashing more quickly.
Once this has been carried out, an appropriate mes-
sage appears on the PC user interface of the central
control unit.
2. Enter the serial number of the status display (sticker
at the back of the device) on the PC user interface of
the central control unit. Now the teach-in procedure
is indicated on the status display by rapid flashing of
the LED at the top left in green.
8

Operation

After teaching in, the individual actuator and transmit
channels can be assigned to the required actions via
the PC user interface of the central control unit.
34