Installation - HomeMatic HM-OU-LED16 Installations- Und Bedienungsanleitung

greatly from that available in the open air.
Besides the transmitting power and the reception cha-
racteristics of the receiver, environmental factors such
as humidity in the vicinity have an important role to
play, as do on-site structural/screening conditions.
eQ-3 AG hereby declares that this device complies
with the essential requirements and other relevant re-
gulations of directive 1999/5/EC.
The full declaration of conformity can be viewed at
www.homematic.com.
6

Installation

- Remove the housing cover at the bottom on the rear
of the device.
- Insert the round plug of the power supply cable into
the power supply socket and fix the cable in the
plastic strip in the centre, as shown in the following
picture:
- Close the cable compartment by replacing the
housing cover. The cable must be led through the
central opening in the housing cover.
- If you wish the raise the device up, fold out the two
supports as shown in the picture.
31