Suntec Wellness KLIMATRONIC DryFix 16 select APP Bedienungsanleitung Seite 11

Drainage
Water tank:
• As soon as the water tank is full, the unit stops working, a warning signal sounds and the 'water tank full'
indication (6) lights up on the display.
Please switch off and unplug the unit.
•
• Carefully pull out the water tank and tip out the water by using the handle.
Please clean and dry the empty tank, and carefully place it back into the machine.
•
•
Continuous drainage:
Please pull the plug out of the outlet.
•
• Please remove the water tank from the appliance as described above and remove
the drainage hose.
Carefully push the water tank back into the appliance without the drainage hose.
•
• You will find the drainage opening on the back of the machine.
Please insert the drainage hose into the opening and place the other end of the hose into a container so
•
that the water can drain off continuously.
• Please make sure that the hose is connected tightly to prevent the water from leaking.
Cleaning and maintenance
To avoid injury, please switch off and unplug the appliance before starting service or cleaning.
Cleaning:
Please unplug the unit.
•
Please clean the unit with a dry and soft cloth. For heavy dirt, please use a slightly damp cloth.
•
• Please do not use any chemical products (such as petrol, alcohol, etc.). The unit's housing and the unit's
surface may be damaged.
Cleaning the dust filter:
Please open the filter cover on the backside of the unit and carefully
•
remove the filter.
To remove dust from this filter, please use a vacuum cleaner or to tap it
•
out carefully.
If the filter is very dirty, wash it in water with neutral detergent, rinse well
•
with water and let it dry.
• Carefully put the filter back into the unit and close the filter cover.
Storage
Please unplug the unit and bundle the power cord.
•
Please empty the water tank, wipe out the tank with a cloth and reinstall it.
•
• Please clean the air filter as described above and then reinstall it in the unit.
For storage, place the unit in an upright position and avoid direct sunlight.
•
Troubleshooting
problem
The unit is not working
The dehumidification
performance is insufficient
cause
Is the unit connected to the power
source?
Is the 'water tank full' indicator
lighting up (water tank is full or
incorrectly placed)?
Is the water tank installed correctly?
Are the air outlet slats open?
The unit is in defrost mode.
Is the air inlet or outlet blocked?
Is the air filter dirty?
Does the unit operate in the fan
mode?
Is the room temperature/humidity too
low high?
solution
Plug-in the unit.
Empty the water tank and install it correctly.
Please check the position of the water tank.
Please open the air outlet slats.
This is a normal process and helps to protect
internal parts. Once the process is complete,
the unit returns to normal operation.
Check the air inlet and outlet and remove
any obstructing objects
Clean the air filter as described in the
operating instructions
Please switch to dehumidification mode.
The unit should be operated at the air
temperature of 5°C - 32°C and a humidity of
10%-90%. The unit cannot dehumidify the air