Cobra 1046 Einbauanleitung Seite 10

USE OF THE SWITCHES USE OF THE SWITCHES USE OF THE SWITCHES
USE OF THE SWITCHES USE OF THE SWITCHES
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
ATTENTION ATTENTION ATTENTION
ATTENTION ATTENTION
When programming the switches, take great care to prevent switch N° 2 When programming the switches, take great care to prevent switch N° 2
When programming the switches, take great care to prevent switch N° 2 When programming the switches, take great care to prevent switch N° 2 When programming the switches, take great care to prevent switch N° 2
from being accidentally set to the ON position. This would cancel the codes from being accidentally set to the ON position. This would cancel the codes from being accidentally set to the ON position. This would cancel the codes
from being accidentally set to the ON position. This would cancel the codes from being accidentally set to the ON position. This would cancel the codes
of the radio controls from the memory of the module. If this happens, the of the radio controls from the memory of the module. If this happens, the of the radio controls from the memory of the module. If this happens, the of the radio controls from the memory of the module. If this happens, the of the radio controls from the memory of the module. If this happens, the
codes must be memorized again in compliance with the RADIO CONTROL codes must be memorized again in compliance with the RADIO CONTROL
codes must be memorized again in compliance with the RADIO CONTROL codes must be memorized again in compliance with the RADIO CONTROL codes must be memorized again in compliance with the RADIO CONTROL
AUTO-LEARNING procedure described in this manual. AUTO-LEARNING procedure described in this manual. AUTO-LEARNING procedure described in this manual.
AUTO-LEARNING procedure described in this manual. AUTO-LEARNING procedure described in this manual.
10
For vehicles with electric locks (unlock and lock
OFF
commands lasting 1 sec.). Set switch 1 to the ON
ON
position to obtain a command lasting 0.2 sec.
The BROWN/WHITE output is activated and should
be connected to the comfort control wire of the original
system in the vehicle. The output remains activated
until the button on the radio control is released.
OFF
Activation of the auto-learning procedure for new radio
controls.
ON
OFF
For vehicles with comfort systems that operate by
lengthening the door locking command (the unlock and
ON
lock commands last for as long as the button on the
radio control remains depressed).
OFF For vehicles with locks of the pneumatic type (unlock
and lock commands lasting 4 sec.).
ON