Daikin Altherma EHYKOMB33AA Installations- Und Bedienungsanleitung Seite 31

Parameter Setting
Position 3-way valve or electric valve
Booster
Step modulation
Minimal space heating rpm
. Minimum capacity space heating pump —
Minimal domestic hot water rpm
(not applicable for Switzerland)
Minimal supply temperature during OT
demand. (OpenTherm thermostat)
. Reversible setting
Start rpm space heating
. Start rpm domestic hot water
(not applicable for Switzerland)
Maximum fan rpm
Set point space heating (flow
temperature) during heating external
domestic hot water tank
. Comfort temperature
. Waiting time after a space heating
demand from a thermostat.
EHYKOMB33AA
Daikin Altherma hybrid heat pump – gas boiler module
4P353067-1L – 2022.09
Range Default
settings
0~3 0
0~1 0
0~1 1
23%~50% 23%
40
23%~50% 23%
10°C~16°C 40°C
0~1 1
50%~99% 50%
50%~99% 50%
45~50 48
60°C~90°C 85°C
0°C / 40°C~65°C 0°C
0 min~15 min 0 min
12 Configuration
Description
▪ 0=Powered during space heating
▪ 1=Powered during domestic
water
▪ 2=Powered during every
demand (space heating, domestic
hot water, eco/comfort)
▪ 3=Zone regulation
▪ 4 and higher=Not applicable
Changing this setting has no effect on
the operation of the unit.
▪ 0=OFF during space
operation
▪ 1=ON during space
operation
It is recommended not to modify this
setting.
Adjustment range 23~50%
(40=propane).
It is recommended not to modify this
setting in case of natural gas.
There is no space heating pump in the
gas boiler. Changing this setting has
no effect.
Adjustment range 23~50%
(40=propane).
It is recommended not to modify this
setting in case of natural gas.
Changing this setting has no effect on
the operation of the unit.
This setting activates the keep hot
function of the gas boiler. It is only
used with reversible heat pump models
and should NEVER be deactivated. It
MUST be deactivated for heating only
models (set to 0).
▪ 0=disabled
▪ 1=enabled
This is the fan rpm before heating
ignition. It is recommended not to
modify this setting.
This is the fan rpm before instant
domestic hot water ignition. It is
recommended not to modify this
setting.
Use this parameter to set the maximum
fan rpm. It is recommended not to
modify this setting.
Do NOT modify this setting on the
boiler. Use the user interface instead.
Temperature used for eco/comfort
function. When the value is 0°C, the
eco/comfort temperature is the same
as the domestic hot water setpoint.
Otherwise, the eco/comfort
temperature is between 40°C and
65°C.
Changing this setting has no effect on
the operation of the unit.
Installation and operation manual
hot
heat
heating
heating
31