ZANKER KEV6340FBB Benutzerinformation Seite 12

KEV6340FBB
220-240 V 50-60 Hz
58 HAD 54 AO
ZANKER
The Safety Instructions
Warning! You must read these!
• Make sure that the appliance is not damaged be-
cause of transportation. Do not connect a damaged
appliance. If it is necessary, speak to the supplier.
• Only an authorized servicing technician can install,
connect or repair this appliance. Use only original
spare parts.
• Only use the built-in appliances after you assemble
the appliance into correct built-in units and work sur-
faces that align to the standards.
• Do not change the specifications or change this
product. Risk of injury and damage to the appliance.
• Fully obey the laws, ordinances, directives and
standards in force in the country where you use the
appliance (safety regulations, recycling regulations,
electrical safety rules etc.)!
• Keep the minimum distances to other appliances
and units!
• Install shock protection, for example install the draw-
ers only with a protective floor directly below the ap-
pliance!
• Keep safe the cut surfaces of the worktop from mois-
ture with a correct sealant!
• Seal the appliance to the work top with no space be-
tween with a correct sealant!
12
All manuals and user guides at all-guides.com
949 594 302 00
6 kW
• Keep safe the bottom of the appliance from steam
and moisture, e.g. from a dishwasher or oven!
• Do not install the appliance adjacent to doors and
below windows! If not, when you open the doors or
windows they can push off hot cookware from the
appliance.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give shock protection.
• Loose and incorrect plug and socket connections
can make the terminal become too hot.
• A qualified electrician must install the connections in
the clamps correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two phase
connection.
• Replace the damaged mains cable with a special ca-
ble (type H05BB-F Tmax 90°C; or higher). Speak to
your local Service Centre.
The appliance must have the electrical installation
which lets you disconnect the appliance from the mains
at all poles with a contact opening width of minimum 3
mm.
You must have correct devices to isolate: line protect-
ing cut-outs, fuses (screw type fuses removed from the
holder), earth leakage trips and contactors.