Remote Control; Care And Cleaning; Cleaning The Grease Filter - AEG DGE5161HM Benutzerinformation

Refer to cleaning the grease filter in care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function press the button
3 seconds.
To activate or deactivate function:
1. To activate function press the button
for 3 seconds.
If the function is activated, the indicator
flashes two times.

6. CARE AND CLEANING

6.1 Notes on cleaning
Cleaning Agents
Keep the hood
clean
Charcoal filter

6.2 Cleaning the grease filter

Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters
carefully from fat. Fat accumulation or other residue may cause fire.
Follow the instructions for cleaning the accessories when filter notification is on. Refer to
Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may
discolour, it has no influence on the performance of the appliance.
The time of saturation of the charcoal filter varies depending on the type of cooking and
the regularity of cleaning the grease filter. The activated charcoal filter is not washable,
cannot be regenerated and must be replaced approximately every 4/6 months of opera‐
tion, or more frequently for particularly heavy usage.
2. To deactivate function press the button
for 3 seconds.
If the function is deactivated, the indicator
flashes ones.
5.4 Remote-control
The appliance can be controlled with a
remote-control. Visit local supplier to buy the
remote-control.
The connection is originally enabled.
for
To connect or disconnect remote-control:
1. Switch off the appliance.
2. Press the
The indicator on control panel flashes twice if
function is enabled and once if disabled.
1. Press the handle of the mounting clip on
the filter panel underneath the hood (1).
57
for 3 seconds.